Problem: I am trying to save a model as XML standard. That is giving the error, "ERWIN_COM_SERVER_NOT_FOUND"
Solution: Please go to an elevated DOS box and register the two DLLs thusly,
EAL.DLL
ERXML.DLL
- In the DOS prompt type in REGSVR32 " and add the full path as copied in step a followed by \EAL.DLL". It should look as follows:
If you have already done that, my next advice would be to run a repair on the erwin installation: go to Control Panel | Add Remove programs Modify and then choose Repair.
Comments
0 comments
Please sign in to leave a comment.